LR3/Disco 3
Secure the clips.
Repeat the above procedure for the other side.
30 .
Connect the MAF sensor electrical connector.
31 .
Connect the throttle body electrical connector.
Secure the clips.
32 .
Connect the MAP sensor electrical connector.
33 .
Install the wiring harness support bracket.
Tighten the bolts to 10 Nm (7 lb.ft).
34 .
Connect the engine wiring harness.
Install the clips on the harness protective cover.
Connect and secure the electrical connectors.
35 .
Install the battery compartment side wall.
Secure the clips.
Install the battery positive cable and grommet.
36 .
Install the fusebox main feed cable.
Install the bolt and tighten to 10 Nm (7 lb.ft).
37 .
Install the engine compartment upper heat shield.
Secure the clips.
Tighten the screw.
38 .
Install the battery. For additional information, refer to
Battery (86.15.01)
(Section 414-01)
39 .
Install the engine cover. For additional information, refer to
Engine Cover - 4.4L (12.30.50)
(Section
501-05)
40 .
Install the radiator access panel.
Tighten the bolts to 10 Nm (7 lb.ft).
41 .
Install the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)
(Section 501-02)