LR3/Disco 3
Installation
1 .
Install the liftgate wiring harness.
Secure the clips.
2 .
If installed, connect the navigation system traffic amplifier electrical connector and antenna cable.
3 .
If installed, connect the diversity amplifier electrical connector and antenna cable.
4 .
Connect the wiper motor electrical connector.
5 .
Connect the license plate lamp electrical connector.
6 .
Connect the heated rear window electrical connectors.
7 .
Connect the high mounted stoplamp electrical connector.
8 .
Attach the liftgate wiring harness.
Install the grommet.
Connect the electrical connectors.
9 .
Install the rear headliner trim panel.
Connect the electrical connector.
Secure with the clips.
10 .
Install the liftgate side trim panel.
Secure with the clips.
Repeat the above procedure for the other side.
11 .
Install the liftgate upper trim panel.
Secure with the clips.
12 .
Install the liftgate lower trim panel. For additional information, refer to
Liftgate Trim Panel (76.34.11)
(Section 501-05)