LR3/Disco 3
Installation
Remove the nut.
9 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the fender rear trim.
Remove the 3 clips.
1 .
Install the fender rear trim.
Secure in the 3 clips.
2 .
Install the front fender.
Install the bolts and tighten to 10 Nm (7 lb.ft).
Install the nut and tighten to 10 Nm (7 lb.ft)
3 .
Install the fender air intake grille.
Install the air ducting.
4 .
Install the lower fender moulding.
Secure in the clips.
5 .
Install the fender moulding. For additional information, refer to
Fender Moulding (76.43.54)
(Section
501-08)
6 .
Install the fender splash shield. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)