LR3/Disco 3
Installation
6 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the seat module bracket.
Remove the 2 Torx bolts.
1 .
Install the seat module bracket.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
2 .
Install the front seat tilt motor assembly.
Tighten the 4 Torx bolts to 10 Nm (7 lb.ft).
Connect the electrical connectors.
3 .
Install the front seat cushion assembly. For additional information, refer to
Front Seat Cushion
(78.10.12/99)
(Section 501-10)
4 .
Install the front seat cushion side finisher.
Secure in the clips.
Tighten the screws.
5 .
Install the front seat control switch.
Secure in the clips.
Tighten the screws.
6 .
Install the front seat. For additional information, refer to
Front Seat (78.10.44/99)
(Section 501-10)