LR3/Disco 3
Liftgate Window Glass (76.31.22)
Removal
NOTE :
Published : May 4, 2004
CAUTION: Always protect paintwork and glass when removing exterior components.
CAUTION: Always protect the interior components when removing body glass.
CAUTION: Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which
subsequently develop into cracks.
The following equipment is required: l Cutting wire and handles l Kent knife l Glazing knife l Glass replacement kit l
Sealant applicator gun l Suction cups l A felt covered table or stand to support glass
1 .
Remove the rear wiper arm. For additional information, refer to
Rear Wiper Pivot Arm (84.35.01)
(Section 501-16)
2 .
Remove the rear wiper drive spindle seal.
3 .
Remove the liftgate lower trim panel. For additional information, refer to
Liftgate Trim Panel
(76.34.11)
(Section 501-05)