LR3/Disco 3
Installation
1 .
Install the rear door window fixed glass.
Make sure the locating peg on the fixed glass has engaged with the door frame.
Tighten the Torx screw to 10 Nm (7 lb.ft).
2 .
Install the channel lining.
3 .
Install the inner waist seal.
4 .
Install the door frame trim.
Clean the component mating faces.
Remove backing tape from adhesive strip.
Secure the clips.
5 .
NOTE :
Wedge the glass in this position.
Raise the rear door glass fully.
Engage the door glass with the channel.
6 .
Install the rear door window motor and regulator assembly. For additional information, refer to
Rear
Door Window Regulator and Motor (86.25.05)
(Section 501-11)
