LR3/Disco 3
Installation
1 .
Install the window motor and regulator assembly.
Tighten the bolts and nuts to 10 Nm (7 lb.ft).
Connect the electrical connector.
2 .
Secure the glass to the glass regulator.
Remove the wedge.
Lower the glass.
3 .
Install the outer waist seal.
4 .
Install the speaker
Tighten the screws.
Connect the electrical connector.
5 .
Install the rear door trim panel. For additional information, refer to
Rear Door Trim Panel (76.34.04)
(Section 501-05)