LR3/Disco 3
Rear Quarter Window Glass (76.81.20)
Removal
NOTE :
Published : Apr 14, 2004
CAUTION: Always protect paintwork and glass when removing exterior components.
CAUTION: Always protect the interior components when removing body glass.
CAUTION: Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which
subsequently develop into cracks.
The following equipment is required:
1 .
Remove the D-pillar upper trim panel. For additional information, refer to
D-Pillar Trim Panel
(76.13.30)
(Section 501-05)
2 .
Remove the rear quarter window glass panel.
Release the 3 clips.
3 .
Disconnect the rear quarter window glass antenna connector.
4 .
WARNING: Eye protection must be worn.