LR3/Disco 3
Installation
Noting fitted position, remove the 4 spacers.
1 .
Carefully remove the sealant from the body to leave a smooth surface.
2 .
Install the windshield glass.
Install the spacers equally as shown.
Use masking tape to establish reference marks as an alignment aid.
3 .
Remove the windshield glass.
Clean the component mating faces.
4 .
Apply etch primer to any bare metal.
5 .
Apply primer over the etch primer.
6 .
Apply glass primer to the sealant face on the windshield glass and allow to cure.
7 .
Apply activator over the old sealant on the windshield glass and allow to cure.
8 .
Fit a pre-cut nozzle to the sealer cartridge, remove the lid, shake out the crystals and fit the cartridge
to the applicator gun.
Modify the nozzle to achieve a bead section in the shape of a right angle triangle with a
base of 8 mm and a vertical height of 12 mm.
9 .
Apply a continuous bead of sealant to the windshield glass as shown.