LR3/Disco 3
2 .
Passenger side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
3 .
Driver side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 lb.ft).
4 .
Connect the instrument panel center reinforcement fibre optic cables.
5 .
Connect the instrument panel center reinforcement electrical connectors.
6 .
Connect the CJB electrical connectors.
7 .
Connect the heater motor electrical connector.
8 .
Connect the electrical connectors to the passenger side lower A-pillar.
9 .
Connect the ground cables to the passenger side lower A-pillar.
Tighten the nuts to 10 Nm (7 lb.ft).
10 .
Connect the electrical connectors to the driver side lower A-pillar.
11 .
Connect the ground cables to the driver side lower A-pillar.
Tighten the nuts to 10 Nm (7 lb.ft).
12 .
Install the adaptor panels.
Tighten the nuts to 10 Nm (7 lb.ft).
13 .
Secure the A/C lines to the bulkhead.
Clean the components.
Install new O-ring seals.
Tighten the bolt to 10 Nm (7 lb.ft).
14 .
Secure the A/C lines to the body.
Tighten the nuts to 10 Nm (7 lb.ft).
15 .
Connect the bulkhead heater hoses.
16 .
Install the instrument panel carrier to bulkhead Torx bolt and tighten to 25 Nm (18 lb.ft).
17 .
Install the plenum chamber panel.
18 .
Install the instrument panel upper section to body bolt and tighten to 10 Nm (7 lb.ft).
19 .
Install the speaker grille.
Secure with the clips.
20 .