LR3/Disco 3
Install the instrument panel center bracket Torx bolts and tighten to 25 Nm (18 lb.ft).
21 .
Attach the heater housing center ducts.
22 .
Connect the drain tubes to the heater housing.
23 .
Connect the steering column intermediate shaft.
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
24 .
Install the transmission selector lever.
Tighten the bolts to 10 Nm (7 lb.ft).
25 .
Attach the transmission selector lever cable.
Install the clip.
26 .
Install the front seats. For additional information, refer to
Front Seat (78.10.44/99)
(Section 501-10)
27 .
With assistance, install the door assembly.
Tighten the bolts to 10 Nm (7 lb.ft).
Attach the retaining clip.
Install the grommet.
Connect the electrical connector.
28 .
Attach the door check strap to the 'A' pillar.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
29 .
Install the driver side closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
30 .
Install the passenger side closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
31 .
Install the cowl side trim panels. For additional information, refer to
Cowl Side Trim Panel
(76.13.27)
(Section 501-05)
32 .
Install the floor console. For additional information, refer to
Floor Console (76.25.01)
(Section 501-
12)
33 .
Refill the cooling system. For additional information, refer to
Cooling System Draining, Filling and
Bleeding (26.10.01)
(Section 303-03)