LR3/Disco 3
Installation
13 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the passenger air bag module.
Remove the 4 nuts.
14 .
Remove the windshield defroster duct.
Remove the 7 screws.
1 .
Install the windshield defroster duct.
Tighten the screws.
2 .
Install the passenger air bag module.
Tighten the nuts to 10 Nm (7 lb.ft).
3 .
With assistance, install the instrument panel upper section.
Tighten the screws.
Attach the wiring harness.
4 .
Tighten the instrument panel upper section speaker aperture bolt to 10 Nm (7 lb.ft).
5 .
Secure the passenger air bag module bracket.
Tighten the Torx screws to 25 Nm (18 lb.ft).
6 .
Connect the passenger air bag module electrical connectors.