LR3/Disco 3
Ignition Lock Cylinder (57.40.28)
Removal
NOTE :
Published : Nov 2, 2004
This procedure is for removal and installation of the ignition lock cylinder. The ignition lock and door lock cylinders
are replaced in sets.
1 .
Fully extend the steering column for access.
2 .
Remove the steering column upper shroud.
Release the 4 clips.
3 .
Remove the steering column lower shroud.
Remove the 3 Torx screws.
Release the steering column adjustment lever.
4 .
Remove the passive coil.
Disconnect the electrical connector.
Release the 2 clips.
5 .
Remove the ignition lock cylinder.
Turn the ignition key to position 1.
Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock
cylinder housing to depress the plunger, and release the ignition lock cylinder.