LR3/Disco 3
Rear Door Latch (76.37.13)
Removal
Published : Jul 15, 2005
1 .
Remove the rear door window motor and regulator assembly. For additional information, refer
to
Rear Door Window Regulator and Motor (86.25.05)
(Section 501-11)
2 .
CAUTION: Release the exterior door handle and screw cover clips from inside the door.
Remove the rear door exterior handle. For additional information, refer to
Exterior Rear Door Handle
(76.58.02)
(Section 501-14)
3 .
Release the remote control cable.
Release the grommet.
4 .
Release the door exterior handle mechanism.
Remove the 2 Torx screws.
Remove the locking pin.
5 .
Remove the rear door latch assembly.
Disconnect the electrical connector.
Remove the 3 Torx screws.
6 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the door latch remote control cable.
Release the cable from the abutment bracket.
Remove the cable from the lever.