LR3/Disco 3
4 .
Install the rear door latch assembly.
Tighten the Torx screws to 10 Nm (7 lb.ft).
Connect the electrical connector.
5 .
Install the door exterior handle mechanism.
Position the mechanism to the door.
Fit the locking pin.
Install and tighten the Torx screws.
6 .
Position the remote control cable to the door.
Install the grommet.
7 .
Install the rear door exterior handle. For additional information, refer to
Exterior Rear Door Handle
(76.58.02)
(Section 501-14)
8 .
Install the rear door window motor and regulator assembly. For additional information, refer to
Rear
Door Window Regulator and Motor (86.25.05)
(Section 501-11)