LR3/Disco 3
Rear Window Wiper Motor (84.35.12)
Removal
Installation
Published : Apr 6, 2004
1 .
Remove the liftgate trim panel. For additional information, refer to
Liftgate Trim Panel (76.34.11)
(Section 501-05)
2 .
Remove the rear window wiper arm. For additional information, refer to
Rear Wiper Pivot Arm
(84.35.01)
(Section 501-16)
3 .
Remove the rear window wiper motor.
Disconnect the electrical connector.
Release the clip.
Remove the 3 nuts.
4 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the 3 rubber insulators.
Remove the metal inserts.
1 .
To install, reverse the removal procedure.
Tighten the nuts to 10 Nm (7 lb.ft).