LR3/Disco 3
5 .
Install the front overhead console.
Connect the electrical connector.
Carefully secure the clips.
6 .
Install both B-pillar upper trim panels. For additional information, refer to
B-Pillar Upper Trim Panel
(76.13.28)
(Section 501-05 Interior Trim and Ornamentation)
7 .
Install both A-pillar upper trim panels. For additional information, refer to
A-Pillar Trim Panel
(76.13.26)
(Section 501-05 Interior Trim and Ornamentation)
8 .
Using T4, configure a new roof opening panel motor.
9 .
If the battery has been disconnected, the one touch and anti-trap function will become inoperative.
Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the
sunroof to complete a full cycle. This will complete the roof opening panel calibration routine and
reset these functions.