LR3/Disco 3
Rear Bumper Cover (76.22.74)
Removal
All vehicles
Published : May 25, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove both rear lamp assemblies. For additional information, refer to
Rear Lamp Assembly
(86.40.70)
(Section 417-01)
3 .
Remove both rear quarter panel mouldings. For additional information, refer to
Rear Quarter Panel
Moulding (76.43.55)
(Section 501-08)
4 .
Remove 4 scews, 2 clips and 2 bolts from the rear bumper cover.
5 .
With assistance, remove 4 clips from the inner edge of the bumper cover.
Tilt the tailgate for access.
Open the tailgate hinge cover.
6 .
Remove the rear bumper cover.
Release from the 12 clips.
If installed, disconnect the parking aid sensor wiring harness electrical connector.