LR3/Disco 3
Vehicles with parking aid
Vehicles with parking aid
Install the parking aid sensor trim panels.
1 .
Install the parking aid sensors.
1 .
Install the parking aid sensor wiring harness.
Connect the electrical connectors.
2 .
Install the bumper insert.
If installed, secure the parking aid sensor wiring harness.
Tighten the screws.
3 .
Install the rear bumper trim panel.
4 .
Install the towing eye cover.
Tighten the screws.
5 .
Install the rear bumper cover.
If installed, connect the parking aid sensor wiring harness electrical connector.
Secure with the clips.
Tighten the screws.
Tighten the bolts to 10 Nm (7 lb.ft).
6 .
Install both rear quarter panel mouldings. For additional information, refer to
Rear Quarter Panel
Moulding (76.43.55)
(Section 501-08)
7 .
Install both of the rear lamp assemblies. For additional information, refer to
Rear Lamp Assembly
(86.40.70)
(Section 417-01)