LR3/Disco 3
Driver Air Bag Module (76.74.01)
Special Service Tools
Driver air bag module remover
501-106
Removal
NOTE :
Published : Jan 4, 2005
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate
information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system.
Disconnect the ground cable first. Never reverse connect the battery.
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Make the SRS system safe. For additional information, refer to
Standard Workshop Practices
(Section 100-00)
3 .
Remove the driver air bag module.
Using the special tool, release the clip.
Repeat the above procedure for the other side.
Disconnect the ground cable.
Release the clips and disconnect the 2 electrical connectors.