LR3/Disco 3
Restraints Control Module (RCM) (76.74.68)
Removal
NOTE :
NOTE :
Installation
Published : May 13, 2004
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate
information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system.
Disconnect the ground cable first. Never reverse connect the battery.
If the restraints control module (RCM) is to be replaced then T4 must be connected and the correct procedures
adhered to, prior to battery disconnection.
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Make the SRS system safe. For additional information, refer to
Standard Workshop Practices
(Section 100-00)
3 .
Remove the floor console. For additional information, refer to
Floor Console (76.25.01)
(Section 501-
12)
4 .
CAUTION: Make sure the wiring harness is protected when cutting the carpet.
Remove the restraints control module (RCM).
Cut the carpet for access.
Disconnect the 2 electrical connectors.
Remove the 3 Torx screws.
1 .