LR3/Disco 3
Side Air Bag Module (76.74.30)
Removal
Installation
Published : Aug 3, 2004
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate
information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system.
Disconnect the ground cable first. Never reverse connect the battery.
1 .
Make the SRS system safe. For additional information, refer to
Standard Workshop Practices
(Section 100-00)
2 .
Remove the front seat backrest cover. For additional information, refer to
Front Seat Backrest Cover
(78.90.08)
(Section 501-10)
3 .
Remove the front seat backrest pad.
Remove the front seat head restraint retaining clips.
4 .
NOTE :
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
Remove the side air bag module.
Release the side air bag module harness.
Remove the 2 nuts.