LR3/Disco 3
panel can be flattened out using controlled application of the sliding hammer.
Cutting out body parts
Depending on how the parts are joined/connected, different tools are suitable for cutting/separating body parts.
NOTE :
NOTE :
Spot-weld mill
Spot-weld mill
Rod sander NOTE :
Any spot welds that are inaccessible for the spot-weld mill (diameter > 8 mm) should be ground out using a rod
sander. The same applies to MIG spot welds or seams.
NOTE :
Any spot welds that are inaccessible for the spot-weld mill (diameter > 8 mm) should be ground out using a
rod sander. The same applies to MIG spot welds or seams.
Rod sander
NOTE :
All other parts like interior equipment, window glass etc. must be protected against flying sparks.
Ensure that the milling depth is set correctly to prevent the remaining flange from being weakened.
Wear protective clothing. Protect any vulnerable body or glass areas against flying sparks. Remove
explosive materials from the vicinity.
Wear protective clothing. Protect any vulnerable body or glass areas against flying sparks. Remove
explosive materials from the vicinity.
Underlying metal parts, wiring harnesses, hoses etc. must not be damaged - remove them
beforehand if necessary.