LR3 (LA) V8-4.4L (2009)
REPAIR PROCEDURE
REPLACE SUSPENSION SYSTEM HEIGHT SENSOR
NOTE:
Left-hand (LH) shown; right-hand (RH) similar.
1. Inspect ride height sensor bracket position for orientation. (Figure 1)
CAUTION:
The bracket shown in Figure 2 may have two or three holes. It is important that the orientation of the bracket is noted and not the number of holes.
NOTE:
The position of the ride height sensor electrical connector remains the same for both original and new sensors.
^
If the orientation of the left-hand rear (LHR) ride height sensor bracket is the same as Figure 2, *continue to step 3.*
^
If the orientation of the LHR ride height sensor bracket is not the same as Figure 2, continue to step 2. If the ride height sensor bracket is installed
as shown in Figure 3, continue to step 2.