Workshop Manuals Factory service & repair Land Rover
01 LT230T Transfer box Overhaul Manual - 3rd Edition02 03 04 05 INTRODUCTION06 07 08 TRANSFER BOX
Land Rover LT230 Transfer Box08 · TRANSFER BOX
08 · General

Mainshaft input gear bearing pre-load

Make
Land Rover
Model
Gearboxes LT230 Transfer Box
Section
OVERHAUL › Mainshaft input gear bearing pre-load
TRANSFER BOXMainshaft input gear bearing pre-load
Mainshaft input gear bearing pre-load – Land Rover LT230 Transfer Box

TRANSFER BOX

OVERHAUL

37

TRANSFER BOX ASSEMBLING

1. Lubricate all components with recommended

oil.

CAUTION: Where use of gaskets is
specified, gaskets must be fitted; do not
use sealant.

Mainshaft input gear bearing pre-load

1. Position mainshaft input gear assembly in main

casing.

2. Up to serial no. 288709E: Fit a new mainshaft

input gear bearing housing gasket, dry on main
casing.

3. All transfer boxes: Fit mainshaft input gear

bearing housing ensuring reference marks are
aligned.

4. Fit 2 M10 x 25 mm bolts and tighten to 25 Nm

(18 lbf.ft).

5. Position suitable DTI with stylus of gauge

contacting end of mainshaft, push mainshaft
rearwards and zero gauge.

6. Push mainshaft forwards and note gauge

reading.

7. Calculate thickness of shim required using the

formula A + B + C = D where:
A = Thickness of installed shim - 3.15 mm
(0.12 in)
B = Recorded end-float
C = Required pre-load - 0.05 mm (0.002 in)
D = Thickness of shim required

8. If an alternative shim is required to establish

correct end-float, proceed as follows:

NOTE: Do not remove mainshaft input
gear bearing housing if bearing pre-load is
correct.

9. Remove 2 bolts, remove mainshaft input gear

bearing housing.

NOTE: Up to serial no. 288709E, retain
gasket on main casing.

10. Using a soft metal drift, carefully drive input

gear bearing track out of bearing housing,
remove shim.

CAUTION: If bearing track is damaged
during this operation, a new track must be
fitted.

11. Select required shim from the range available.

NOTE: Shims are available from 3.15 to
4.00 mm (0.12 to 0.16 in) thickness rising
in increments of 0.05 mm (0.002 in).

12. Fit selected shim and using a suitable mandrel,

fit input gear bearing track.

13. Fit mainshaft input gear bearing housing and

temporarily secure using 2 M10 x 25 mm bolts
tightened to 25 Nm (18 lbf.ft).

Parts & tools for this job For Land Rover Gearboxes

As an Amazon Associate we earn from qualifying purchases.