Range Rover P38
12
ENGINE
NEW RANGE ROVER
6
REPAIR
CRANKSHAFT REAR OIL SEAL
Service repair no - 12.21.20
NOTE: Seal and carrier are supplied as an
assembly.
Remove
1. Disconnect battery negative lead.
2. Remove flywheel.
See this section.
3. Remove sump.
See this section.
4. Remove 6 bolts securing seal carrier to cylinder
block.
5. Remove seal carrier from location dowels.
6. Collect gasket and discard.
Refit
7. Ensure mating faces are clean.
8. Position new gasket.
9. Lubricate seal guide LRT-12-107 with engine oil.
Position over crankshaft boss.
10. Lubricate oil seal lip. Position seal carrier
squarely over guide. Locate carrier onto dowels.
11. Remove guide.
12. Secure carrier with bolts.
M6, Tighten to
10 Nm (7 lbf.ft)
M8, Tighten to
22 Nm (16 lbf.ft)
13. Fit sump.
See this section.
14. Fit flywheel.
See this section.
15. Reconnect battery negative lead.
ENGINE AND GEARBOX
Service repair no - 12.37.01.99
Remove
1. Position vehicle on four post lift.
2. Remove battery.
See ELECTRICAL, Repair.
3. With assistance, release bonnet struts from body
locations. Retain bonnet in vertical position using
stay clips.
WARNING: Only open the bonnet to the
vertical position with the vehicle on a
horizontal surface in the workshop. This
position is not intended to be used outdoors
where the bonnet could be affected by winds.
4. Remove inlet manifold.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
5. Remove ECM.
See FUEL SYSTEM, Repair.
6. Remove 2 screws securing engine harness
clamp to battery tray. Collect harness clamp.