Range Rover P38
BMW DIESEL
37
REPAIR
OIL FILTER - UP TO 1998MY
Service repair no - 12.60.02
Remove
1. Drain engine oil.
See SECTION 10,
Maintenance.
2. Position cloth beneath oil filter casing to catch
spillage.
3. Remove bolt securing cover to filter casing.
Collect ’O’ ring and discard .
4. Remove cap. Collect ’O’ ring and discard.
5. Remove filter element and discard.
NOTE: Oil in filter casing will run back into
sump once cover is removed.
Refit
6. Clean filter casing and cap.
7. Fit filter element.
8. Using new ’O’ rings, position cap. Secure with
bolt. Tighten to
33 Nm (24 lbf.ft)
9. Replenish engine oil.
See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
10. Start engine. Run at 2500 rev/min until oil
pressure warning light extinguishes.
NOTE: Oil pressure warning light will
extinguish after approximately 5 seconds.
11. Stop engine. Recheck oil level.