Range Rover P38
LAND ROVER V8
27
REPAIR
KNOCK SENSOR (KS) - up to 99MY
Service repair no - 18.30.28 - Sensor - LH
Service repair no - 18.30.30 - Sensor - RH
CAUTION: Due to the sensitivity of the
sensors, do not apply tape or sealant to
sensor threads.
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. RH Sensor Only: Remove starter motor.
See
ELECTRICAL, Repair.
3. Disconnect sensor multiplug.
4. Remove sensor from cylinder block.
Refit
5. Ensure sensor location in cylinder block is clean.
6. Fit sensor. Tighten to
16 Nm (12 lbf.ft)
CAUTION: Failure to tighten sensor to
correct torque will result in malfunction or
sensor damage.
7. Connect sensor multiplug.
8. RH Sensor Only: Fit starter motor.
See
ELECTRICAL, Repair.
9. Remove safety stands. Lower vehicle.