Range Rover P38
CHASSIS AND BODY
1
ADJUSTMENT
FRONT DOOR
Service repair no - 76.28.07
NOTE: Adjustment should not be
necessary unless door or hinges have
been renewed.
Alignment of door to aperture.
1. Gain access to ’A’ post hinge bolts by removing
relevant wheel arch liner.
See Repair.
2. Slacken 2 bolts securing striker to ’B/C’ post.
3. Slacken 6 bolts securing door hinges to ’A’ post.
4. With assistance, adjust door position in aperture.
Tighten hinge bolts to
30 Nm. (22 lbf.ft)
Profile adjustment, door skin/frame to adjacent
body panels.
5. Slacken 4 bolts securing hinges to door.
6. With assistance adjust inboard/outboard position
of door. Tighten hinge bolts to
30 Nm. (22 lbf.ft)
CAUTION: Ensure that leading edge of
door is flush with adjacent panels or wind
noise will result.
7. When alignment of door is correct, adjust height
and inboard/outboard position of striker. Tighten
striker bolts. Check for correct door latching.
8. Slacken bolts and readjust striker position as
necessary. Tighten striker bolts to
22 Nm. (16
lbf.ft)
9. Fit wheel arch liner.
See Repair.
REAR DOOR
Service repair no - 76.28.08
NOTE: Adjustment should not be
necessary unless door or hinges have
been renewed.
1. Open door and slacken 2 bolts securing striker
to ’D’ post.
2. Open front door and slacken 6 bolts securing
rear door hinges to ’B/C’ post.
3. With assistance, adjust door position in aperture
and tighten hinge bolts to
25 Nm. (18 lbf.ft)
4. To adjust profile of door skin and frame relative
to adjacent body panels, slacken 4 bolts
securing hinges to door.
5. With assistance adjust inboard/outboard position
of door. Tighten hinge bolts to
25 Nm. (18 lbf.ft)
CAUTION: Ensure that leading edge of
door is flush with adjacent panels or wind
noise will result.
6. When alignment of door is correct, adjust height
and inboard/outboard position of striker. Tighten
striker bolts and check for correct door latching.
7. Slacken bolts and readjust striker position as
necessary. Tighten striker bolts to
22 Nm (16
lbf.ft).