Range Rover P38
82
AIR CONDITIONING
NEW RANGE ROVER
12
REPAIR
COMPRESSOR - DIESEL
Service repair no - 82.10.20
Remove
1. Raise vehicle on four post lift.
2. Disconnect battery negative lead.
3. Raise lift.
4. Discharge air conditioning system.
See
Adjustment.
5. Remove drive belt.
See this section.
6. Disconnect compressor multiplug.
7. Remove 2 bolts securing high and low pressure
pipes.
8. Release pipes from compressor. Discard ’O’
rings. Plug pipes and connections
9. Remove 4 bolts securing compressor to
mounting bracket. Remove compressor.
NOTE: On RHD vehicles, bolts cannot be
removed completely.
Refit
10. Position compressor on bracket ring dowels.
Secure with bolts.
11. Remove plugs from pipes and compressor.
12. Lubricate new ’O’ rings with compressor oil. Fit
to connections.
13. Connect pipes to compressor. Secure with bolts.
Tighten to
23 Nm. (17 lbf.ft)
14. Connect compressor multiplug.
15. Fit drive belt.
See this section.
16. Evacuate and recharge air conditioning system.
See Adjustment.
17. Lower lift.
18. Reconnect battery negative lead.
EVAPORATOR
Service repair no - 82.25.20
Remove
1. Remove heater.
See HEATING AND
VENTILATION, Repair.
2. Remove screw inside centre vent duct.
3. Remove 2 bolts securing evaporator to heater
unit.
4. Remove evaporator from heater unit.
Refit
5. Reverse removal procedure.