Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Range Rover P38 Technical Bulletins10 · Body, trim and restraints
10 · Body & interior

Transit protection film removal

Make
Land Rover
Model
Range Rover P38 Technical Bulletins
Section
Transit protection film removal › Transit protection film removal
Body, trim and restraintsTransit protection film removal

TRANSIT PROTECTION FILM REMOVAL

Model
Range Rover Discovery Freelander
Affected vehicles
All vehicles destined for ‘Deep Sea Markets’ e.g: North America/Canada Japan South Africa Australia RE - ISSUE INFORMATION: The period during which transit protection film may remain in place on the vehicle is extended from 110 to 200 days. Please destroy your existing copy and replace with this Issue 2.
Date
1998-10-07
Reference
Bulletin 0023, CDS ref L8459bu
Transit Protection Film Removal – bulletin page 1

Bulletin text

Range Rover Discovery Freelander

AFFECTED RANGE:

All vehicles destined for ‘Deep Sea Markets’ e.g: North America/Canada

RE - ISSUE INFORMATION: The period during which transit protection film may remain in place on the vehicle is extended from 110 to 200 days. Please destroy your existing copy and replace with this Issue 2.

PROBLEM:

TRANSIT PROTECTION FILM REMOVAL

CAUSE:

During May 1998, transit protection film was introduced for certain markets. The film is applied to the bonnet and drivers door panel on all affected vehicles. In addition, all Freelander models have film applied to the roof panel and to the 3 door softback.

ACTION:

The transit protection film MUST be removed from vehicles no later than 200 days from date of despatch. The removal procedure is as follows: 1. Peel the film from the corners, pulling the film back over itself by 180 ° to the panel. NOTE: If the panels are hot, (panel temperature in excess of 45 Γ C), the temperature must be reduced by spraying water onto the film surface. This will ensure that no adhesive remains on the panel surface. 2. Wash vehicle with water. Wipe along the edges of previously protected panels with panel cleaner to remove any adhesive trace which may have bled from the film edges. 3. The film is a biodegradeable polypropylene material and is suitable for landfill disposal. Your Environmental Agency should be consulted for specific local requirements.

Bulletin N o : 0023 L8459bu 2 07.10.98

Japan South Africa Australia

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.