Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Range Rover P38 Technical Bulletins10 · Body, trim and restraints
10 · Body & interior

Vehicle tools jack-rattle

Make
Land Rover
Model
Range Rover P38 Technical Bulletins
Section
Vehicle tools jack-rattle › Vehicle tools jack-rattle
Body, trim and restraintsVehicle tools jack-rattle

VEHICLE TOOLS JACK-RATTLE

Model
New Range Rover
Affected vehicles
Upot 313500
Date
1995-05-30
Reference
30/05/95
Vehicle Tools Jack-Rattle – bulletin page 1

Bulletin text

Vehicle Tools Jack - Rattles

MODEL

New Range Rover

DETAIL

Information has been received from the dealer network, indicating a rattle emanating from the vehicle tool stowage area, Investigations have identified the cause to be the jack strap routing allows the strap to slip off the top end of the jack, and becoming loose and causing a rattle.

ACTION REQUIRED

Check all vehicles for the routing of the jack retaining strap, and re-route were necessary following the procedure below.

PARTS INFORMATION

Not applicable

PROCEDURE

1. Loosen the catch on the jack retaining strap.

2. Pass the strap under the pump mechanism on the jack and over the main body of the jack, as shown in the illustration opposite.

3. Tighten the strap and catch.

30/05/95

NRR/76/24/95/EN

AFFECTED VEHICLES

LP Upot 313500 LH LJ LD

WARRANTY

Normal warranty policy and procedure apply

COMP. CODE

8T4K

SRO

76.10.89/38 Re-position tool retaining strap 0.05 hour

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.