Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Range Rover P38 Technical Bulletins12 · Electrical and instruments
12 · Electrical

Unable to mobilise diesel

Make
Land Rover
Model
Range Rover P38 Technical Bulletins
Section
Unable to mobilise diesel › Unable to mobilise diesel
Electrical and instrumentsUnable to mobilise diesel

UNABLE TO MOBILISE DIESEL

Model
New Range Rover Diesel Derivatives
Affected vehicles
from 316176
Date
1997-02-12
Reference
12/02/97
Unable To Mobilise Diesel – bulletin page 1

Bulletin text

TestBook Information

Unable to Mobilise Diesel

MODEL

New Range Rover Diesel Derivatives

DETAIL

We have received a small number of reports which indicate some vehicles are unable to mobilise using CD DRG0002. This only occurs on vehicles with robust immobilisation from the above Vin number where both Diesel EDC and the BeCM are changed and programmed to the vehicle together. The cause being that the message received by the BeCM from the EDC diagnostic does not enable it to identify that an EDC unit in ‘’factory mode’’ is robust. Before you can successfully match the EDC unit to the BeCM the EDC unit must know that it is robust.

ACTION REQUIRED

Having changed both the BeCM and the EDC unit you should follow the procedure detailed below.

PARTS INFORMATION

Not applicable

PROCEDURE

1. Use CD DRG0002. 2. Select appropriate model year. 3. Run EDC security immobilisation diagnostic ensuring that you proceed through a stage where the EDC is changed from ‘’factory mode’’ to ‘’robust’’. 4. Either.

A. The BeCM has not been programmed at all (ie it is a new BeCM which not been accessed by TestBook). In this circumstance you should do normal BeCM programming - follow the usual instructions from TestBook. OR

B. The BeCM has already been programmed (ie you have already tried to start the vehicle and it will not start). In this circumstance you should carry out the following: Enter the BeCM. Enter BeCM programming. Change engine type to Petrol. Programme BeCM-do not try to start vehicle After TestBook has re-read the configuration, change the engine type back to Diesel Re-programming the BeCM - the engine will now start.  Rover Group 1996

12/02/97

TB001/97/EN

AFFECTED VEHICLES

LP from 316176 LH LJ LD

WARRANTY

Normal warranty policy and procedures apply

COMP. CODE

Not applicable

SRO

Refer to bulletin TB006/96 for individual times

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.