Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Range Rover P38 Technical Bulletins02 · Engine
02 · Engine

Engine will not start / starts intermittently

Make
Land Rover
Model
Range Rover P38 Technical Bulletins
Section
Engine will not start / starts intermittently › Engine will not start / starts intermittently
EngineEngine will not start / starts intermittently

ENGINE WILL NOT START / STARTS INTERMITTENTLY

Model
Range Rover Discovery Series II Defender
Affected vehicles
All V8 derivatives with Bosch Engine Management System in VIN ranges: Range Rover - XA 410483 to 1A 446786 - Introduction of model to XA 907212 (System 1) Discovery Series II - Introduction of model to 1A 296165 (System 2) - XA 159810 to YA 199999 Defender - YA 600000 to 1A 602857
Date
2000-11-15
Reference
Bulletin 0029, CDS ref L8623bu
Engine Will Not Start / Starts Intermittently – bulletin page 1
Engine Will Not Start / Starts Intermittently – bulletin page 2

Bulletin text

Range Rover Discovery Series II Defender

AFFECTED RANGE:

All V8 derivatives with Bosch Engine Management System in VIN ranges: Range Rover XA 410483 to 1A 446786 Introduction of model to XA 907212 (System 1) Discovery Series II Introduction of model to 1A 296165 (System 2) XA 159810 to YA 199999 Defender YA 600000 to 1A 602857

PROBLEM:

ENGINE WILL NOT START / STARTS INTERMITTENTLY The engine will not start due to the starter motor becoming inoperative.

CAUSE:

Poor electrical connection between the main battery lead and the starter motor solenoid.

ACTION:

At the final VINs above, the torque setting for the battery lead connection to the starter motor was increased from 10 Nm to 18 Nm. Where a customer complaint as above is confirmed, secure the battery connection to the starter motor as follows: 1. Disconnect earth lead from battery. 2. Raise vehicle, (Discovery and Defender only). 3. Locate battery lead to starter motor solenoid connection, (arrowed illustration). 4. Tighten solenoid nut to the new torque of 18 Nm. 5. Lower vehicle, (if necessary) reconnect battery earth lead.

Bulletin N o : 0029 L8623bu 1 15.11.2000

lead

in

and

PARTS INFORMATION:

Not applicable

WARRANTY CLAIMS: Use Complaint Code: 7C1L

Use S.R.O.: 86.60.89/27 Time allowance: Range Rover - 0.10Hrs Discovery and Defender - 0.20Hrs

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.