Workshop Manuals Factory service & repair Land Rover
01 General and service information02 Engine03 Fuel, emissions and engine management04 Cooling system05 Manifolds and exhaust06 Transmission and axles07 Steering and suspension08 Brakes09 Wheels and tyres10 Body, trim and restraints11 Heating and air conditioning12 Electrical and instruments13 Service and recall actions
Land Rover Range Rover P38 Technical Bulletins09 · Wheels and tyres
09 · Steering & suspension

Tyre pressures

Make
Land Rover
Model
Range Rover P38 Technical Bulletins
Section
Tyre pressures › Tyre pressures
Wheels and tyresTyre pressures

TYRE PRESSURES

Model
New Range Rover
Affected vehicles
311859 Onwards
Date
1995-04-12
Reference
12/04/95
Tyre Pressures – bulletin page 1

Bulletin text

Tyres Pressures

MODEL

New Range Rover

DETAIL

From the above Vin all tyre pressures on New Ranger Rover, will be inflated to 50 lbs/In/2 to prevent the possibility of tyre flat spotting during extended periods without movement.

Therefore, during Pre-Delivery Inspection all tyre pressures inclusive of the sparewheel, must be checked and adjusted to the correct pressures before handover to the customer.

Reference should be made to the workshop and vehicle handbook to determine the correct tyre pressures for the size and make of tyre.

ACTION REQUIRED

For information only, check tyre pressures during the Pre-delivery inspection, and adjust as necessary

PARTS INFORMATION

Not Applicable

PROCEDURE

Tyre Pressures for New Range Rover:

235/TOR16 - Normal all load conditions

255/65R16 - Normal all load conditions

255/55R18 Normal all load conditions

Tyre Pressures Front Rear 1.9 Bar 2.6 Bar 28 Psi 38 Psi 2.0 Kgf/Cm2 2.8 Kgf/Cm2

12/04/95

NRR/74/04/95/EN

AFFECTED VEHICLES

LP 311859 Onwards LH LJ LD

WARRANTY

Not Applicable

COMP. CODE

Not Applicable

SRO

Not Applicable

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.