Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2102002.png)
from terminal A(C2307) via a US wire; the right hand lamp is fed from terminal B (C2607) via a UG wire. Each lamp is grounded via an N wire. A feed
for the switch illumination is provided on a SR wire, and is grounded via an N wire at C556.
Alternating flashing headlamps
The Headlamp Flash system utilises a feature built in to the Lighting Control Module. The feature requires enabling with Testbook/IDS. When the
feature is enabled, an LCM output (C2040-46) requires switching to ground to activate the alternately flashing lamps. A switch for this feature is
mounted on the facia.
LCM output (C2040-46) is connected to the switch (C3267) on an UW wire. With the switch in the on position, the output is grounded on a B wire. An
ignition feed is provided on a GY wire to the switch to illuminate a status lamp when in the on position. A feed from the panel illumination circuit is
provided on an SR wire to illuminate the switch.
Intercom system
Options box in rear luggage area
Amplifier for intercom
System description and operation
In order to activate it, use the green switch button on / off.
Communicate as follows :
From the inside to the outside : press the yellow button while speaking. Once you have released it, the outside listening is permanent.
If you want to increase the interior volume of the loud speaker, turn the potentiometer clock wise.
The amplifier is located the rear luggage area inside the 'options box'.
Microphone for the interior
