Range Rover (LM) V8-4.4L (2009)
Parking Assist Distance Sensor: Service and Repair
Front Outer Parking Aid Sensor
Front Outer Parking Aid Sensor
Removal
1. Remove the front bumper extension panel screw.
2. Release the front lower edge of the fender splash shield for access.
CAUTION: Make sure damage does not occur to bumper cover. Failure to follow this instruction may result in damage to the vehicle.
NOTE: Access to the parking aid sensor is gained from the rear of the bumper cover.
3. Remove the front outer parking aid sensor.
-
Disconnect the electrical connector.
4. Remove the parking aid sensor trim panel.
Installation
1. Install the parking aid sensor trim panel.
CAUTION: Make sure damage does not occur to bumper cover. Failure to follow this instruction may result in damage to the vehicle.
2. Install the front outer parking aid sensor.
-
Connect the electrical connector.
3. Install the front LH fender splash shield.
-
Install the screw.