Range Rover (LM) V8-4.4L (2009)
Front Fender Liner: Service and Repair
Fender Splash Shield
Service Repair No - 76.10.48
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the front wheel.
3. Remove the front LH fender splash shield.
^
Remove the 3 nuts.
^
Remove the 13 screws.
^
Disconnect the tire pressure monitoring system front antenna electrical connector.
4. NOTE: Do not disassemble further if the component is removed for access only.
Remove the tire pressure monitoring system front antenna.
^
Release the 2 clips.
Installation
1. Install the tire pressure monitoring system front antenna.
2. Install the front LH fender splash shield.
^
Connect the tire pressure monitoring system front antenna electrical connector.
^
Tighten the screws.
^
Tighten the nuts.
3. Install the front wheel.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).