Range Rover (LM) V8-4.4L (2009)
Rear Fender Liner: Service and Repair
Rear Fender Splash Shield
Service Repair No - 76.10.49
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise the rear of the vehicle.
2. Remove the road wheel.
3. Remove the 2 clips securing the rear fender splash shield to the rocker panel and rear bumper.
4. Remove the 3 plastic nuts securing the rear fender splash shield.
5. Remove the 4 screws securing the rear fender splash shield.
6. Remove the rear fender splash shield.
Installation
1. Install the rear fender splash shield.
^
Install the plastic nuts.
^
Install the screws.
^
Install the clips.
2. Install the road wheel.
^
Tighten the road wheel nuts to 140 Nm (103 ft. lbs.).
3. Lower the vehicle.
^
Remove the stands.