Range Rover (LM) V8-4.4L (2009)
8. Release the 2 air suspension lines.
^
Release from the 2 clips.
9. Using suitable hydraulic jacks, support the lower arms.
10. NOTE: LH illustration shown, RH is similar.
Release the LH and RH rear shock absorbers from the lower suspension arms.
^
Remove the 2 nuts and bolts.
11. Using a suitable hydraulic jack, support the rear subframe.
12. Remove the 2 diagonally opposite subframe mounting bolts.
^
Remove the 2 special washers.
13. Use the rear shock absorber bolts to support the rear subframe.
^
Install the special washers.
^
Install the bolts to a minimum depth of 16 mm (0.63 inches).
14. Release the rear subframe.
^
Remove the 2 bolts.
^
Remove the 2 special washers.
^
Lower the subframe by a maximum of 100 mm (3.94 inches).
^
Remove the 4 spacers.
15. NOTE:
^
The rear subframe bushes must be replaced as a set.