Range Rover (LM) V8-4.4L (2009)
^
Take note of the fitted position of the bush.
Install the special tools, to the rear subframe bushes.
16. Using the special tool, remove the rear subframe bushes.
^
Remove the special tool.
Installation
1.
CAUTION: Allow the sealant to set for 24 hours before any vehicle load is applied to the bushing.
Position the rear subframe bush.
^
Apply LR012582 sealant to the contact face of the new bush.
^
Install the special tools.
2. Using the special tool, install the rear subframe bush.
3. Repeat the procedure on the bush diagonally opposite.
4. Raise the rear subframe.
^
Remove the 2 bolts.
^
Install the bolts to a minimum depth of 16 mm (0.63 inches) through the opposite bushes.
5. Lower the subframe by a maximum of 100 mm (3.94 inches).
6. Remove and install the remaining 2 bushes.
7. Raise the rear subframe and locate on the dowels.
^
Install the spacers.
^
Remove the bolts supporting the rear subframe.
8. CAUTION: Make sure that the spacers are correctly located to the bushes prior to tightening.
Secure the rear subframe.
^
Install the special washers.
^
Tighten the bolts to 165 Nm (122 ft. lbs.).
9. CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
Secure the LH and RH rear shock absorbers to the lower suspension arms.