Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2343003.png)
^
If no kinks or twists are found, proceed to step 16.
12.
Connect the drain tube(s).
13.
Pour a small amount of water into the affected drain hole / tube(s).
14.
Verify water has pooled on the ground at the affected drain hole / tube(s).
15.
Release the affected drain tube(s) from the roof opening panel.
16.
Inspect the drain tube(s) for damage (hole, tear, etc).
^
If no damage is found, use compressed air to blow out the affected drain tube(s).
^
Pour a small amount of water into the repaired drain hole / tube(s).
^
Verify water has pooled on the ground at the repaired drain hole / tube(s).
^
If damage is found, proceed to REPLACE DAMAGED SECTION OF DRAIN TUBE(S) below.
REPLACE DAMAGED SECTION OF DRAIN TUBE(S)
1.
Ensuring a straight cut, remove the damaged section of drain tube(s).
2.
Using the removed section as a template, cut a replacement section from a new drain tube (AKJ760042 or AKJ60030).
3.
Using Loctite 401 (STC50546), bond the replacement section to the remaining section of drain tube.
CAUTION:
Follow the sealant's instructions to allow sufficient time for curing.
4.
Cover the joint with Polyurethane sealant (Betafil - locally sourced) and allow sufficient time for curing.
5.
Install the repaired drain tube.
6.
Pour a small amount of water into the repaired drain hole / tube(s).
7.
Verify water has pooled on the ground at the repaired drain hole / tube(s).
^
If water pools on the ground, refer to Workshop Manual (GTR) Section 76.64.15 to install the headlining.
^
If water does not pool on the ground, refer to REPLACE FRONT DRAIN TUBE / REPLACE REAR DRAIN TUBE as necessary below.
REPLACE FRONT DRAIN TUBE
CAUTION:
Care should be taken when cutting drain tube; water may have collected in the tube due to blockage.
1.
Access the affected A-Pillar drain tube(s) through the body side from the inside of the vehicle.
