Range Rover (LM) V8-4.4L (2009)
2.
Cut the affected front drain tube(s) as shown by 'X' in Figure 1.
3.
Carefully pour a small amount of water into the bottom section of the drain tube(s).
^
If water pools on the ground, a blockage exists in the lower section of the tube; proceed to step 4.
^
If no water pools on the ground, a blockage exists in the upper section of the tube; proceed to step 18.
4.
Push the plastic drain tube retaining clip into the bottom of the A-pillar.
5.
Remove the drain tube grommet from the sill.
6.
Attach a length of welding wire securely around the top of the lower section of drain tube:
^
Wrap wire around the drain tube and tap into place.
7.
Remove the drain tube from the vehicle:
^
Carefully pull the bottom of the train tube downwards and outwards, ensuring the welding wire follows.
^
Stop pulling once the welding wire has taken the place of the drain tube.
^
Leaving the welding wire in place inside the A-pillar, remove the drain tube from the welding wire.