Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2386007.png)
1. Install the front seat backrest lower rear cover.
^
Secure the front seat backrest cover lower trim panel to the 2 clips.
2. Install the 2 clips to the front seat backrest lower rear cover.
3. Install the front seat backrest hinge cover.
^
Secure the clip.
^
Install the 2 screws.
4. Install the seat control switch.
5. Install the front seat side trim panel support.
^
Secure the 2 clips.
6. Secure the 2 lower tension straps to the front seat base.
^
Reposition the front seat backrest cover.
7. Install the front seat.
8. Connect the battery ground cable.
Front Seat Cushion Cover
Front Seat Cushion Cover
Service Repair No - 78.30.01
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
CAUTION: The front passenger seat occupant classification sensor is available only as a service kit. No attempt should be made to replace
individual components. Failure to follow this instruction may result in personal injury.
1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front seat.
4. Release the 2 lower tension straps from the front seat base.
^
Reposition the front seat backrest cover for access.
5. Remove the front seat side trim panel support.
^
Release the 2 clips.
