Range Rover (LM) V8-4.4L (2009)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor
Front Wheel Speed Sensor
Service Repair No - 70.65.30
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the wheel and tire.
3. Disconnect the wheel speed sensor electrical connector.
^
Open the electrical connector housing.
^
Release the electrical connector from the clip.
4. Release the front wheel speed sensor wiring harness.
5. Remove the front wheel speed sensor.
^
Release the clip.
^
Remove the bolt.
Installation
1. Install the front wheel speed sensor.
^
Apply anti-seize compound to the wheel speed sensor.
^
Tighten the bolt to 8 Nm (6 ft. lbs.).
^
Secure the clip.
2. Secure the front wheel speed sensor wiring harness.
^
Connect the wheel speed sensor electrical connector.
^
Secure the electrical connector in the clip.
^
Close the electrical connector housing.
3. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).