Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1443002.png)
5. Tie the brake caliper housing aside.
6. Remove the brake caliper anchor plate.
^
Remove the 2 bolts.
7. Measure the brake disc thickness at four points around the brake disc.
^
Renew the brake disc if the thickness is less than the service limit, or if the maximum thickness variation is exceeded. Brake disc thickness,
NEW = 30 mm, Service limit = 27 mm.
8. Using the special tool, install a dial indicator gauge to the brake caliper lower mounting.
^
Position the dial indicator gauge plunger 5 mm in from the outer edge of the brake disc.
9. Install the wheel nuts.
^
Install spacer washers under the wheel nuts.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
10. Rotate the brake disc one revolution to measure the brake disc run-out.
^
Brake disc run-out must not exceed 0.05 mm.
11. If the brake disc run-out is outside the limit. Remove the brake disc.
12. Make sure the brake disc and hub mating surfaces are clean.
13. Install the brake disc.
^
Tighten the Torx screw to 35 Nm (26 ft. lbs.).
