Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1443003.png)
14. Install the wheel nuts.
^
Install spacer washers under the wheel nuts.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
15. Rotate the brake disc one revolution to measure the brake disc run-out.
^
Brake disc run-out must not exceed 0.05 mm.
16. If the brake disc run-out is still outside the limit, install a new brake disc and/or hub.
17. Remove the dial indicator gauge and the special tool.
WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
18. Clean the caliper housing and anchor plate using brake cleaning fluid.
19. Install the anchor plate.
^
Tighten the bolts to 275 Nm (203 ft. lbs.).
20. Install the brake caliper housing and fit the top bolt.
^
Tighten the bolt to 32 Nm (24 ft. lbs.).
21. Install the brake pads.
^
Install the two clips.
22. Rotate the brake caliper downwards.
^
Tighten the bolt to 32 Nm (24 ft. lbs.).
23. Connect the brake pad wear indicator sensor.
24. Secure the brake hose retaining bracket to the wheel knuckle.
^
Tighten the bolt to 22 Nm (16 ft. lbs.).
25. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
