Range Rover (LM) V8-4.4L (2009)
Installation
NOTE: Remove and discard blanking plugs
1. Install the brake fluid reservoir
^
Clean the component mating faces
^
Install new seals
NOTE: Remove and discard blanking plugs
2. Connect the pre-charge pump feed hose
^
Secure the clip
3. Connect the low brake fluid warning indicator switch electrical connector
^
Secure the wiring harness
4. Bleed the brake system
Brake Fluid Reservoir - Vehicles With: Standard Brake
Brake Fluid Reservoir - Vehicles With: Standard Brakes
Service Repair No - 70.25.31
Removal
CAUTION: If brake fluid is spilt on the paint work, the affected area must be immediately washed down with cold water.
1. Disconnect the low brake fluid warning indicator switch electrical connector.
^
Release the wiring harness.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Position cloth to collect fluid spillage.
2. Disconnect the pre-charge pump feed hose.
^
Release the clip.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
3. Remove the brake fluid reservoir.
^
Release the 2 clips.
^
Remove and discard the 2 seals.