Range Rover (LM) V8-4.4L (2009)
Installation
NOTE: Remove and discard the blanking caps.
1. Install the brake fluid reservoir.
^
Clean the component mating faces.
^
Install the new seals.
NOTE: Remove and discard the blanking caps.
2. Connect the pre-charge pump feed hose.
^
Secure the clip.
3. Connect the low brake fluid warning indicator switch electrical connector.
^
Secure the wiring harness.
4. Bleed the brake system.
Brake Fluid Reservoir - Vehicles With: High Performance Brakes
Brake Fluid Reservoir - Vehicles With: High Performance Brakes
Service Repair No - 70.25.31
Removal
CAUTION: If brake fluid is spilt on the paint work, the affected area must be immediately washed down with cold water.
1. Disconnect the low brake fluid warning indicator switch electrical connector.
^
Release the wiring harness.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Position cloth to collect fluid spillage.
2. Disconnect the pre-charge pump feed hose.
^
Release the clip.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
3. Remove the brake fluid reservoir.
^
Release the 2 clips.
^
Remove and discard the 2 seals.