Range Rover (LM) V8-4.4L (2009)
Installation
NOTE: Remove and discard the blanking caps.
1. Install the brake fluid reservoir.
^
Clean the component mating faces.
^
Install the new seals.
NOTE: Remove and discard the blanking caps.
2. Connect the pre-charge pump feed hose.
^
Secure the clip.
3. Connect the low brake fluid warning indicator switch electrical connector.
^
Secure the wiring harness.
4. Bleed the brake system.
Brake Master Cylinder - Vehicles With: Standard Brakes
Brake Master Cylinder - Vehicles With: Standard Brakes
Service Repair No - 70.30.08
Removal
1. Remove the brake fluid reservoir.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
Remove the brake master cylinder.
^
Disconnect the 3 brake pipes.
^
Remove and discard the 2 nuts.
^
Remove and discard the seal.
Installation
WARNING: Make sure that new nuts are installed.
1. Install the brake master cylinder.
^
Clean the component mating faces.
^
Install a new seal.
^
Tighten the nuts to 26 Nm (19 ft. lbs.).
NOTE: Remove and discard the blanking caps.
2. Connect the brake pipes.
^
Tighten the nuts to 14 Nm (10 ft. lbs.).